| Warthog Territory Forums http://www.warthogterritory.net/forum/ |
|
| F111 titanium jet prop holder http://www.warthogterritory.net/forum/viewtopic.php?f=9&t=3293 |
Page 1 of 1 |
| Author: | the pope [ 21 Jun 2003, 08:43 ] |
| Post subject: | |
I have here what i have been told is the inner atachment device used to hold the fins of a jet engine in. it's roughly 35 cm outter diameter and 20cm inside with a heap of these angles spoke like things on the outside( i suppose the blades lock into these by pressure fit or something). now i was wondering because it has a nice circular hole in the centre how easy it would be to possibly mould into a case side panel using maybe some car body filler (bog) to make it look like part of the side panel instead of something bolted on. it fits nicely inside the area of a side panel and isnt too heave as to make it awkward. ill try to get pics as soon as i get hold of a digi cam. also might be able to get more parts for use, tho not enough to make an entire engine LOL any other suggestions from you guys would be appreciated because i sure as hell dont know what i can do right atm. from: http://forums.overclockers.com.au/showt ... did=181240 This thing he says he has, would it be a colectors item? Here is a pic of it: http://imagestore.ugbox.net/images.php? ... e8fb674c91 http://imagestore.ugbox.net/images.php? ... 447662901c pope |
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|